Code Definition

B2592 — PSD Not Fully Closed (Module Commanded Successfully)

System: Body  |  Type: Generic (OBD-II Standard)  |  Make: Generic

About B2592

B2592 is a generic (obd-ii standard) body diagnostic trouble code. It belongs to the B-prefix family of codes, which covers body, interior, airbag, or comfort-electronics faults.

Scanning & clearing: Body (B) codes are often stored in the body control module, airbag module, or climate module. A basic OBD-II tool usually will not read body codes — an enhanced or OEM-level scan tool is typically required.

Because B2592 is a generic OBD-II code, its base definition is shared across manufacturers. The specific diagnostic steps, reference values, and repair procedures can vary by vehicle, and the TaT Diagnostic Assistant includes verified procedures submitted by working technicians.

Code Information

The B2592 fault code indicates that after the Power Sliding Door (PSD) control module successfully commanded the door to close, the door did not reach the fully closed and latched position. The module sends the close command and monitors latch detent feedback, motor position counter, and obstruction sensor data, and sets this code when the close cycle completes but the latch reports the door is not in the primary closed state. This commonly results from latch misalignment, weatherstrip interference, cinch motor weakness, or latch sensor failure. When set, the door may sit slightly ajar, the co...

Join TaT to view the complete code information and diagnostic details.

Quick Facts