Code Definition

B0785 — 2 wheel drive high range lamp Circuit malfunction

System: Body  |  Type: Generic (OBD-II Standard)  |  Make: Generic

About B0785

B0785 is a generic (obd-ii standard) body diagnostic trouble code. It belongs to the B-prefix family of codes, which covers body, interior, airbag, or comfort-electronics faults.

When B0785 is stored, the module has detected a signal or supply voltage higher than the expected operating range; and a plausibility fault — the measured value is in the electrical range but is not consistent with expected operating behaviour.

Scanning & clearing: Body (B) codes are often stored in the body control module, airbag module, or climate module. A basic OBD-II tool usually will not read body codes — an enhanced or OEM-level scan tool is typically required.

Because B0785 is a generic OBD-II code, its base definition is shared across manufacturers. The specific diagnostic steps, reference values, and repair procedures can vary by vehicle, and the TaT Diagnostic Assistant includes verified procedures submitted by working technicians.

Code Information

DTC B0785 is a generic body code that indicates the transfer case control module (TCCM), body control module, or instrument cluster has detected an electrical malfunction in the two-wheel drive (2WD) high-range indicator lamp circuit. This indicator is used to confirm to the driver that the transfer case is in 2-High mode, with drive sent to the rear (or front) axle only and the front (or rear) axle disconnected. The driving module commands the lamp on or off using a low-side or high-side driver and monitors the resulting circuit voltage; the code sets when the monitored voltage does not match...

Join TaT to view the complete code information and diagnostic details.

Quick Facts