Code Definition

P182E — Internal Mode Switch-invalid Range Error

System: Powertrain  |  Type: Manufacturer-Specific  |  Make: Holden

About P182E

P182E is a manufacturer-specific powertrain diagnostic trouble code recorded for Holden vehicles. It belongs to the P-prefix family of codes, which covers engine, transmission, emissions, or fuel-system faults.

When P182E is stored, the module has detected a plausibility fault — the measured value is in the electrical range but is not consistent with expected operating behaviour.

Scanning & clearing: A generic OBD-II scan tool will usually read and clear powertrain (P) codes. For live data, freeze-frame capture, and bi-directional tests you may need a more capable scan tool that supports the vehicle's ECM protocol.

P182E is a manufacturer-specific code. The same code string on a different make may have a different meaning. Always confirm the code's definition against the vehicle's service information for the specific make and model under test.

Code Information

This DTC is set when the transmission control module (TCM) detects an invalid or implausible combination of signals from the Internal Mode Switch (IMS), also known as the Transmission Range Switch. The IMS provides information about the selected gear position (e.g., Park, Reverse, Neutral, Drive) via a set of voltage signals. If the input signals from the IMS do not correspond to any valid gear position or fall outside of the predefined logic table stored in the TCM, this fault code is triggered. This may indicate electrical issues or mechanical misalignment in the switch assembly.

Quick Facts